Production data for insulating boards and tiles

If you have selected a surface fixture for the layer (insulation material) or a tile (facing layers) on the Production tab of the Insulation material catalog or Brick/tile catalog and insulating boards or tiles are placed in the respective wall layers, these individual elements are transferred to production in accordance with the following rules:

• So that the large number of insulating boards and in particular tiles can be transferred, identical uncut insulating boards and/or tiles are transferred in one common fixture. A separate polygon with the shape of each insulating board or tile is transferred.
  A fixture is limited to a maximum of 99 geometric elements, due to the requirements of the UNITECHNIK interface.
• When cut, insulating boards and tiles are always transferred as their own fixtures.
• For cut and uncut insulating boards and tiles, the Length and Width of the uncut element as listed in the Insulation material catalog or the Brick/tile catalog are always transferred as the length and width (field 88888 and 99999 in line 7 of the MOUNTPART block).
  A placement angle is not transferred. It can only be obtained indirectly from the following geometric element.
• If an insulating board is only cut to avoid an opening on the inside of the board, all of the fixtures of the originally uncut insulating board are transferred in one common fixture.
• When tiles are transferred, the Joint depth specified in the Placement pattern catalog is entered in field 6666 in line 7 of the MOUNTPART block.
• If the Mark "smooth edge" for cut tiles option is selected in the Brick/tile catalog, the Unitechnik file identifies the uncut edges of the tile with the line attribute Smooth edge (Bit 8) .