Module(s): Catalogs Module(s): Catalogs
'General' tab
Created on:
Date of creation of the data record.
Last modified:
The most recent modification date.
Name:
You can enter any name. This name is displayed in the Type list box of the basic parameters for slab element design if the Description box is empty. This way, you can enter a short name for the catalog and a detailed description for the design.
Description:
You can enter any name. This name is displayed in the Type list box of the basic parameters for slab element design.
Brick type:
Selection box of the brick/tile catalog. These bricks are used for element design. You can use the Change Hollow Blocks/Concrete Strips/Filling Objects/Bricks tool to modify the bricks.
You can define how bricks are displayed in the brick/tile catalog.
Slab thickness:
The standard value for slab thickness.
Concrete topping:
Thickness of concrete layer placed over the bricks.
Dead weight:
Weight of panel including the bricks in [to/m2]. The program uses this value to calculate the weight based on the length and width of the panel.
Use half bricks:
When you select this check box, the program also uses element widths of which the specified brick is divided (halved) in the middle.
'Panel widths' tab
Dimensions:
At least one element width must be of the Entire panel type. In addition, you need to enter all possible fitted panel widths.
The program tries to create a valid design based on these element widths, the support adjustment between the minimum and maximum support and the in-situ concrete fitted panel alternative.
to insert a new entry above the selected entry in the table.
to add an entry to the end of the table.
to delete the entry selected in the table. '->Fact.' tab
Assignment of the individual entries to the relevant factories.
The selected entry is applicable to the selected factories. If no factory is selected, the entry is valid for all the factories.
| (C) Allplan GmbH | Privacy policy |
