Copying Settings from a Stirrup Mesh

Tool(s): Secondary Meshes - Place Individually + Secondary Meshes - Edge Reinforcement + Secondary Meshes, Freeform - Place Stirrup Mesh

You can identify stirrup meshes as follows:

For the section placement

Using the Enter Stirrup Mesh tool.

1. Click Match.
2. Click an existing stirrup mesh in section or the corresponding schema.
3. Position the identified mesh where you require and set parameters, if applicable.
4. Click OK to confirm the entries.
5. Select a view for the mesh or define a new view. Specify the spatial orientation.
6. Place the label for the mesh displayed in section (you can define the text angle before you do this) and, if necessary, create the leader manually.
   

For the view-type placement

Using the Place Individually tool.

1. Click Match.
2. Click an existing stirrup mesh in section or the corresponding schema or an existing placement in view.
   A single, planar mesh with the dimensions of the unfolded stirrup mesh is created.
3. Adapt the parameters to be changed for the view of the stirrup mesh displayed in the preview.
4. Position the preview as required.
   The stirrup mesh is then created.