Reinforcement for trimming, placing parameters

Tool(s): Reinforcement for Trimming

longit / transv:

Diameter: when you have enabled the Copy diameter from basic reinforcement option for the reinforcement in panel transverse or longitudinal direction in Properties, this diameter is displayed in the data entry box.
This diameter is used as the starting value for automatic placement.

When the Copy diameter from basic reinforcement option is not enabled, click the data entry box to select the bar diameter from a table.
In this case, the diameter and number specified are always used to create the reinforcement. The program does not determine the required reinforcement (also applies for automatic placements).

Number/Nr=: maximum number off for reinforcement in longitudinal/transverse direction If the Copy diameter from basic reinforcement option is enabled for automatic placement, the program automatically increases the diameter when the number off specified is not sufficient to create the required reinforcement.

Distance: use this to set the distance [m] between individual bars.

Anchorage up to edge: click this button to place the reinforcement in the longitudinal/transverse direction on both sides up to the panel edge.

Note: When you have selected manual placement, the program displays the existing and required reinforcement for information purposes.