Reinforcement for trimming, properties

Tool(s): Reinforcement for Trimming

After you have clicked the button, you can make the following settings in the Reinforcement for Trimming dialog box:

General

Minimum length of reinforcement for trimming

Minimum length of recesses

Minimum width of recesses

Offset to recess edge

Parameters for reinforcement for trimming

in panel longitudinal direction

• Copy diameter from basic reinforcement: when this option is enabled, the maximum diameter of the basic reinforcement is used for the reinforcement for trimming.
• Copy diameter/number off value from toolbar
  

in panel transverse direction

• Copy diameter from basic reinforcement: when this option is enabled, the maximum diameter of the basic reinforcement is used for the reinforcement for trimming.
• Copy diameter/number off value from toolbar
  

as_req from

as_longit: when this option is enabled, reinforcement for trimming in transverse direction is calculated from the existing longitudinal reinforcement.

as_transv: when this option is enabled, reinforcement for trimming in transverse direction is calculated from the existing transverse reinforcement.

Use

Bars/girders
At the moment only bars can be used.