Tool(s): Wall design, divisions + Modify divisions Tool(s): Wall design, divisions + Modify divisions
The following parameters do not apply to the Wall panel design mode. The program generates wall panels horizontally so that they are on top of each other. At the moment, they are not automatically separated by maximum length or weight. Divisions are created in the form of connections at columns and corners.
Wall element
Minimum length
Smaller elements are not created.
Maximum length
Larger elements are not created.
Maximum weight
Specifies the maximum element weight. If you define one (or more) crane locations in the drawing, the program calculates the maximum weight from the loaded radii. If the resulting weight is less than the value set, division is based on the loaded radii.
Rotate from height
So that the panel fits on the pallet, the element is rotated internally as soon as this value is reached.
Maximum rotated length
Maximum length for rotated elements; this value usually corresponds to the pallet width.
Round-off value / Spacing grid
It is a good idea to specify a round-off value. When designing brick walls, the program uses this value for the grid dimension. If you have selected Brick wall for the design type, this entry is not available, as you specify the grid dimension in the Material Definition.
Opening
Division
Select this check box if openings are to be divided. Otherwise, the division point is moved beside the opening by the value specified.
Min. offset
Minimum offset of a division point to an opening.
Joint
Width
Width of joints for divisions.
Offset value (double walls only)
The joint of the two leaves is moved by the value specified. You can enter positive and negative values. This value is applied to the invisible leaf.
Miter for double wall
At obtuse angle
If this check box is selected, 45° miters are created.
| (C) Allplan GmbH | Privacy policy |
