|
|
|
Create structural members by assigning cross sections along the axes.
Read the introduction in Project navigation window/Structural members.
1. Girders
1.1 Create a new girder
Follow the instructions in Girders.
Within this step you can already interactively define the subsequent points 1.2 and 1.3.
1.2 Define the stations of the girder
Follow the instructions in the submenu Stations.
1.3 Assign a cross section to the girder
Follow the instructions in the submenu Cross sections.
1.4 Assign the respective tables to the variables in the cross section
Follow the instructions in the submenu Variations.
[1.5 Further definitions for the analysis model]
The following definitions are only required for generating an analysis model.
Read the introduction in the submenu Additional menus for the analysis model.
[1.5.1 Beam Elements]
Follow the instructions in the submenu Beam Elements.
[1.5.2 Material]
Follow the instructions in the submenu Material.
[1.5.3 Groups]
Follow the instructions in the submenu Groups.
2. Piers
2.1 Create a new pier
Follow the instructions in Piers.
Within this step you can already interactively define the subsequent points 2.2 and 2.3.
2.2 Define the stations of the pier
Follow the instructions in the submenu Stations.
2.3 Assign a cross section to the pier
Follow the instructions in the submenu Cross sections.
2.4 Assign the respective tables to the variables in the cross section
Follow the instructions in the submenu Variations.
[2.5 Further definitions for the analysis model]
The following definitions are only required for generating an analysis model.
Read the introduction in the submenu Additional menus for the analysis model.
[2.5.1 Beam Elements]
Follow the instructions in the submenu Beam Elements.
[2.5.2 Material]
Follow the instructions in the submenu Material.
[2.5.3 Groups]
Follow the instructions in the submenu Groups.
|
(C) ALLPLAN GmbH |
Privacy policy |
