Configuration(s): slab programs: single panel schema, half floor Configuration(s): slab programs: single panel schema, half floor
'Miscellaneous' tab
EPA automatic startup:
Yes: after you have selected the panels and the plotter (if necessary), the output of the single panel schemas starts automatically. In this case, you cannot change the printout design.
No: after you have selected the panels and the plotter (if required), you can define the printout design before the single panel schemas are output.
Where there are several drawings in one border
Arrange drawings:
From top to bottom: where several panels are printed in one border, then the panels are arranged from top to bottom (working from left to right in columns).
From left to right: where several panels are printed in one border, then the panels are arranged from left to right (working from top to bottom).
Free format arrangement:
Offset between 2 drawings [cm]:
If the drawings are printed to scale, this value sets the minimum distance between two drawings.
Please ensure that you also have the correct settings for the plotter configuration parameters as these can affect the single panel schema.
AnzKopien (number of copies)
Format (=border format)
Orientation (portrait/landscape)
Number of drawings in x-direction
Number of drawings in y-direction
Scale of panel drawing
Headings:
Text height [cm]:
Specify the text height to be used for the heading.
Draw border around heading:
Yes: the program draws an extra border around the heading.
No: the program does not draw a border around the heading.
'Project data' tab
Contract number:
Client:
Construction project:
Component:
Construction site:
Edited by:
Slab over:
Layout number:
Printed on:
Enter which of these should appear in the footer (yes) and which should be left off (no).
Text height for project data [cm]:
Specify the text height for the project information in the footer.
| (C) Allplan GmbH | Privacy policy |
