Girder offset according to panel length

Module(s): Configurations

Girder spacings for half floors (slab program). This defines which girder spacings are to be used for which panel lengths.

Number of definitions

Enter the number of different spacings you require.

This value restricts the available 3 blocks. (If you want to distinguish between three ranges of length, you must set the number of definitions to 3.)

If you want the girder distribution to be by slab width (see girder spacing catalog), you must set the number of definitions to 0, otherwise this configuration has a higher priority.

Valid up to panel length:

The spacing entered next is to be used up to this panel width.

Maximum girder spacing:

The largest possible girder spacing (standard spacing).

Minimum girder spacing:

The smallest possible girder spacing (for fitted panels).

Girder edge distance:

The distance from the slab edge to the girder.