NC generator, special production

Module(s): NC generator

F1 *Element

Use this tool to select elements by clicking on them.

F3 *Area

Use this tool to define an area by clicking on two points.

F8 Sector+

You can zoom into a section of the drawing (magnify).

F9 Sector-

Resets the zoom back to previous.

S1 *Automatic

Use this to specify the elements to be included in automatic production. These are all the elements that are not highlighted in color. Click an element highlighted in color to assign it to automatic production.

S2 *Special

Use this to specify the elements to be included in special production. These elements are not transferred by the NC generator. The border and mark number of the selected elements are highlighted in color. To assign elements to automatic production, select S1 *Automat and click the relevant panels.

S3 PalRot

This is where you can enable or disable the rotation mode for panels. Selected panels whose borders are highlighted in color are rotated by 90° in production. You can deactivate these panels by disabling the mode and clicking the panels again.