Placing mode: in rotation

Tool(s): Additional Bars, Freeform - Place

To place in rotation

1. Enter a placing arc to define the placing area. Three methods are provided:
   • Click Circle to define the placing arc based on a center point and radius. The circle generated initially can then be reduced to an arc by setting a point and entering the included angle.
   • Click 2-Pt to define the path of the placing arc based on the diameter given by two points you set. The circle generated initially can then be reduced to an arc by setting a point and entering the included angle.
   • Click 3-Pt. The first two points you set define the location of the circular path.
2. Specify the mark's position for the placement. The following options are provided:
   • Inside to place the reinforcement within the placing arc.
   • Middle to place the reinforcement so that it is centered on the placing arc.
   • Outside to place the reinforcement outside the placing arc.
   • Click Align to adopt the basic orientation in space of the identified mark and to place the reinforcement in direct alignment.
3. Adjust the parameters for the position of the mark and click OK to confirm the settings.
4. Select the placing parameters.

   Note: When placing in series, you cannot modify the defined placement region.

5. Click OK to confirm the settings. The placement is created.
6. Set the dimension line parameters and place the placement dimensioning.
   or
   click Cancel to skip dimensioning entirely.
7. Set the label parameters and place the placement label (you can define the text angle in advance), create the manual leader if required
   or
   click Cancel if you want to skip labeling.
8. When you have configured Allplan to create a layer symbol ( Options, Reinforcement, Labels page) and you have not yet placed this symbol along with the label, you can now select a layer symbol in the input options and click the drop-in point or a bar segment
   or
   you can skip layer marking by pressing ESC.