Bending Shape: Straight Bar as Point

Tool(s): Secondary Bars, Freeform - Enter

Define parameter settings for the mark properties and click OK to confirm.
Then enter the bar length and place the bar.

The following parameters are available:

Mark

Use this to set mark number. The highest possible mark number possible is 9999.

Diameter and the corresponding buttons / /

Use this to assign a cross-section diameter to the bar.

Steel grade

Use this to select the reinforcing steel grade.

Schema bar

If this option is set to Yes, a schema is created in addition to the definition bar. The definition bar itself is not labeled.
If it is set to No, on the other hand, the bending shape is created as a definition bar.