Dimension line parameters

You can set the arrowhead size for dimension lines here.

(A) Dimension line
(B) Size of arrowhead

Note: Dimension text and arrowheads are always entered in mm and as absolute values, and they behave like text when you change the reference scale.

You can select an arrowhead here.

You can choose to show or hide the dimension line here.

In this mode, the values for the elevation dimensioning are always displayed with a plus sign
In the case of other types, the values are not preceded by a plus sign.

In this mode, the elevation symbols and values are placed where you click.

Define the format properties (

Pen,

Line,

Color and

Layer) for the different components of the dimension line:
Dimension line, Extension lines, Symbol and Numbers/text
The settings you make apply to all the components of the dimension line (provided the Same for all elements check box is active for the setting in question).

You can configure the program not to display Dimension text and you can define separate settings for the following parameters:

Font, Text height, Aspect (always select 1 for TrueType fonts; otherwise, they will be distorted), Bold (only for TrueType fonts), Italics and Underline.

This option applies blanking to the dimension text. It is placed on a fill in background color. This ensures that the dimension text is always visible even if you place it over a pattern or hatching style.

This setting governs the actual distance between the dimension text and its dimension line.

You can enter the distance in [mm] or [inches] (values between -99 and +99 mm). This value defines the distance between the bottom or top of the dimension text and the dimension line.

(A) Distance

Define the Position of dimension text: centered or to the left or right of the arrowhead.

You can set the unit of dimensioning here.

The dimension text computed by Allplan only appears rounded-off on-screen. For internal calculations, Allplan still uses the original value. To round off dimension text, Allplan uses the value set in [mm] or [inches].

For example:

Round-off value of 5 [mm] 0.1137m 0.115m

Round-off value of 10 [mm] 0.2384m 0.24m

Round-off value of x/4 [inches] 0.12m=4.72" 4 3/4"

Enter the number of decimal places here.

Enter the number of trailing zeroes here. Enter the number of trailing zeroes used to pad out empty decimal places.

Example:

The value 1.01 with:

4 decimal places, 4 trailing zeroes will display as 1.0100

4 decimal places, 2 trailing zeroes will display as 1.01

You can toggle the exponent-style numeric format on/off.

This option is only available when Dim. Text Unit is set to m, cm.

Fraction is only available for the US units ', " and inches.

The decimal places of dimension text are always written as fractions. The denominator of the fraction depends on the setting for Round-off value. Allplan may reduce the fraction.

When you select the Fraction option, Allplan will use the value set as the common denominator for all fractions. In this case, Allplan will not reduce the fraction.

This option is only available in elevation dimensioning mode.

When you enable this check box, the dimension text is preceded by a plus sign (provided the value is positive).

When you disable this check box, the dimension text is displayed without a plus sign.

With plus sign	Without plus sign

This option is only available in Elevation dimensioning and Pegging Out mode.

When you enable this check box, zero values are preceded by ±.

Option enabled	Option disabled

You can enter up to 10 characters that are to appear in front of the dimension text.

Example:

NN625

You can enter up to 10 characters that are to appear after the dimension text.

Example:

24cm.

When you select this option, all extension lines get a fixed length and stretch towards the dimensioned points.

You can copy the parameters of an existing dimension line into the dialog box and modify them, if necessary.

Click the arrow on the right to open a list with the 20 favorites you used last.