Configuration of list generator, slab recesses

'Recesses 1' tab

Measurement of recesses:

Project-related: all recesses are included even when only a part of the project (some stacks, for example) is billed. When you bill another part, all recesses are listed again. trans-panel recesses are not double counted (conforms to VOB - the German Construction Contract Procedures).

Panel-related: Trans-panel recesses are converted to two separate recesses of undefined size.

Stagger project-related recesses:

according to limit area: recesses are listed in the measurement sheet and/or invoice based on the limit area for recesses (one value only) defined in the Production Data Transfer tool. An example:
8 recesses < 1 m²
4 recesses >= 1 m²

according to stagger: recesses are listed in the measurement sheet and/or invoice according to the values defined here. An example:
3 recesses < 0.15 m²
2 recesses < 0.50 m²
3 recesses < 1.00 m²
4 recesses >= 2.00 m²

Note: With the panel-related setting, recesses are always billed according to stagger.

Stagger recesses according to size:

Recesses are combined based on the limit areas you enter here.

Ignore recess area [m2]: (only when recesses are billed on a panel-related basis)

Recesses greater than this value are subtracted from the element area.

Prompt for ignore recess area:

You can set here if there are different threshold values of recess areas to be ignored. You will be prompted each time an invoice is created. If you enter 'No' here, then the fixed value entered in Ignore recess area is used.

'Recesses 2' tab

Calculation of shutter length of recesses:

Yes: the shutter length of recesses is calculated.

No: the shutter length of recesses is not calculated.

List round recesses:

Round recesses are included.