TCL Command TASK LATSTAB

Description

The lateral stability test is performed. Further information can be found in the description of the corresponding dialog.

Arguments

The basic arguments correspond to those of all tasks (see TCL Command TASK). The other arguments must be entered in the form "key=value".

There are the following additional specific, predefined arguments:

Key	Value	unit	Meaning
env	envname	TEXT	Overlay/combination A
env1	env1name	TEXT	Overlay/combination B
env2	env2name	TEXT	Overlay/combination C
env3	env3name	TEXT	Overlay/combination D
day	resday	INT	Day of overlay in the case of a combination, default: resday = day1
resname	rname	TEXT	Name for saving the results
stage	svalue	ENUM	State from the list {HANGING, SEATED}
label	lname	TEXT	Reference of the support conditions via SUPPORTAT
pos1	xpos1	LSTRUCTD	Position of the first bearing, relative to the start of the girder
pos2	xpos2	LSTRUCTD	Position of the second bearing, relative to the start of the girder
alpha	avalue	ANGLED	Superelevation angle
hr	hrvalue	LSTRUCTD	Height of the rotation point above the ground (roll center)
hcg	hcgvalue	LSTRUCTD	Height of the beam’s center of gravity over the road
zmax	zvalue	LSTRUCTD	Distance from the center line of the vehicle to the center of the twin tires
k	kvalue	MOMENT/ANGLE	Total torsional rigidity in X
camber	cvalue	LSTRUCTD	Superelevation in the center of the beam
looptol	loop	LSMALL	Eyelet tolerance
sweeptol	sweep	LSMALL	Roll tolerance

Scopes

TASKS, CONTAINER

Examples

TASK LATSTAB 28 LOCAL 0 7 "env=U+W" "env2=CH+W" "resname=res28" "stage=HANGING" \

"pos1=2.740" "pos2=38.760" "alpha=3.440" "hr=0.610" \

"hcg=2.743" "zmax=0.950" "k=509.000" "camber=0.051" \

"looptol=6.350" "sweeptol=1.042" "descr=Lateral stability - hanging"

For a description of the arguments, please refer to the description of the associated dialog and the collection of examples of Allplan Civil installation.