Define property set point for tension

Definition of Tensions type property set points

The positions in the cross-section at which tension results are to be calculated and output are defined via tension points.

To create a new Tension type property set point

1. Select the desired (previously created) property set of the tension type via the property set menu of the cross-section in the navigation tree.

   This property set is now active and all subsequent definitions of property set points are assigned to this property set.

2. Click Insert Property Set Point.
3. Click on the point of intersection of two parametric lines or a parametric point to define the position of the tension point.

   Alternatively, you can set the position directly with the mouse cursor.

4. Directly create additional Tension type property set points (back to 3.) or confirm the entry via the Enter key or by clicking the last defined point again.

   Note: Press ESC to cancel the definition of the entire point series.