'Supports' configuration entry

Configuration BubbleDeck: Design + Cobiax Slab: Design

"Support, bar projection" tab

End face, bearing width:

[cm] The standard value for bearing width in span direction. This value also applies to inclined edges.

Longit. side, bearing width:

[cm] The standard value for bearing width transverse to span direction.

Bottom / top layers of bars
End face, bar projection:

[cm] The standard value for bar projection in the span direction. This value also applies to inclined edges.

Bottom / top layers of bars
Longit. side, bar projection:

[cm] The standard value for bar projection transverse to the span direction.

'Label' tab

Text in labels of ...

You can use a pattern and variables to specify the text in labels for supports, bar projection and chamfered elements.
In the case of chamfered elements, you can also enter the text to be used in the label while defining these elements.

Pattern:

Entry of text to be used in label. The variable values (floating point numbers) are entered as placeholders by means of formatting characters (%g or %f). The program replaces the formatting characters with the corresponding values. When you use %g, trailing zeros and the decimal point are only output if this is necessary.

You can also define how the numbers are to be output:

%3g: Returns at least 3 characters (including decimal point); spaces are added.

%03g: as shown; however, zeros (for example, 002) are added.

%.3f: output of 3 decimal places.

%6.3f: output of a total of 6 characters (including decimal point) and 3 decimal places.

Variable:

Enter an arithmetical expression for each wildcard character. Use "," as a separator. Arithmetical expressions can be arithmetical operators, numbers, and variables.
Auflager and EisUebU can be used as variables for supports and bar projection; dx and dz can be used for chamfered elements.

Examples

You want to label supports and bar projection with xx.x/xx.x.

In the ”Pattern” line, enter %g/%g
Entry in 'Variable' line: Auflager,EisUebU

You want to label chamfered elements with Ce:xx.x/xx.x.

In the ”Pattern” line, enter Sr:%.1f/%.1f
Entry in 'Variable' line: dx,dz

List support, bar projection beyond 0/0:

If the support and the bar projection is 0, then the label '0/0' at the edges can be suppressed.