Reference point for segment label

To avoid misinterpretation, you should add a reference point to segment labels that are greater than 90°. It is a good idea to choose the Automatic setting, which is the default.

Automatic:	All the segment labels that consist of the numbers 6, 8, 9 and 0 (in the middle) and that are not given a decimal point can be misinterpreted. To avoid this, points are added to the end of these labels. (e.g. "126", "89.", "68.9", "90", "608.", "88.")
Off:	No reference points are added to segment labels. (e.g. "126", "89.", "68.9", "90", "608.", "88.")
On:	Reference points are added to all segment labels without decimal points, regardless of the numbers included in the labels. (e.g. "126", "89.", "68.9", "90", "608.", "88.")

Note: The setting you make here also affects the segment labels of bent-up meshes and applies to any new schema you create. The segment labels of existing schemas are not affected.