Configuration(s): pallet plans Configuration(s): pallet plans
'Panel' tab
Show standard girders:
Show secondary girders:
Show shear girders:
Show longitudinal bars:
Show cross bars:
Show secondary bars:
Show fixtures:
Show stirrup groups:
Show stirrup meshes:
Show secondary meshes:
Click the entity or element you want the program to show.
Label linear fixtures:
This sets whether or not linear fixtures are to be labeled.
Panel number bottom left as placed:
The panel number is written in the bottom left corner in relation to its position, i.e. in relation to the span direction (position in the placing drawing).
Bars between girders:
As an alternative to drawing the longitudinal bars you can show the number and the diameter of the bars that are between the girders, e.g. 3x12.
Panel scale - showing walls:
By element: the same scale is used for both leaves of a double wall. The scale is based on the larger panel.
By panel: the scale for each panel can be different.
'Dimensioning' tab
Dimension panel shape:
Dimension standard girders:
Dimension secondary girders:
Dimension shear girders:
Dimension longitudinal bars:
Dimension cross bars:
Dimension secondary bars:
Dimension fixtures:
Dimension stirrup groups:
Dimension stirrup meshes:
Dimension secondary meshes:
Click the entity or element you want the program to dimension.
'Table' tab
Include table:
Sets whether or not the table with reinforcement or fixtures is to be output.
You can use the following parameters to set each value shown in the table:
Include area of panel:
Include panel thickness:
Include panel volume:
Include concrete grade:
Include steel grade:
Include concrete cover:
Longitudinal and cross bar layers shown as totals:
"Longitudinal and cross bar layers shown as totals" means that in addition to the listing the individual bar marks, the program shows the bar layers as totals, e.g. 11 pieces L: d8/20cm.
The reinforcement quantity specified in the table always represents the longitudinal bars, cross bars and the girders based on the enclosing rectangle of the element! In the case of panels and/or recesses of irregular geometry, individual longitudinal bars, cross bars and girders of the basic reinforcement may be excluded! This is ignored!
Include reinforcement type:
The table includes the reinforcement type.
Panel area including bar overlap:
”Panel area including bar overlap” means that the bar overlaps are added to the area of the panel.
| (C) Allplan GmbH | Privacy policy |
