Table configuration entry

Configuration(s): wall programs: single slab schema

You can set which information is included in the table.

Weights in:

Tonnes, kilonewtons

Include reinforcement type:

Include as-Value:

The reinforcement quantity specified in the table of the single slab schema always represents the longitudinal bars, cross bars and the girders based on the enclosing rectangle of the element! In the case of panels and/or recesses of irregular geometry, individual longitudinal bars, cross bars and girders of the basic reinforcement may be excluded! This is ignored!

Include basic mesh:

Include concrete cover:

Include girders, longitudinal and cross bars:

full: the offsets of the bars and girders are averaged (panel dimension divided by number).

short: the offsets are not included.

Offst_from_ReiCat: the offsets are taken from the reinforcement type catalog.

Offst_bet_Gir: the offsets actually used are printed.

See note on the Include as-Value setting.

Include detailed bar list:

no: the table of the external single slab schema only includes basic reinforcement
e.g. 20 d8/l=456cm (maximum length).

in addition: the table of the external single slab schema includes basic reinforcement and a summarized list of all the existing bars and their actual lengths.

instead: the table of the external single slab schema only includes a summarized list of all the existing bars and their actual lengths.

See note on the Include as-Value setting.

Include element diagonal at solid walls:

The program includes the size of the element diagonal at solid walls.

EPA recesses ignored i.e. not measured in area [m²]:

Recesses smaller than or equal to the value entered are ignored in the measurements. The parameter only applies for the calculation of the area of a single slab schema. It has no influence on the analysis calculations.

Include lifting bolts:

Stirrup shapes

Number of columns for stirrup shapes:

Enter the number of columns for stirrup shapes you wish to be used in the table.

Width of a drawing as a number of characters:

Enter the number of characters available for the width of a drawing of a stirrup shape.

Height of a drawing as a number of characters:

Enter the number of characters available for the length of a drawing of a stirrup shape.