Meshes configuration entry

Configuration(s) Double wall: calculation + Concrete wall: calculation + Wall panel: calculation + Thermal wall: calculation + Sandwich wall: calculation

Configuration entries for the calculation of reinforcement of concrete walls that are created using the

• Design tool (Concrete wall: calculation)
• Wall Element Design tool (Concrete wall (new): calculation)

Configuration entries for the calculation of reinforcement of double walls that are created using the

• Design tool (Double wall: calculation)
• Wall Element Design tool (Double wall (new): calculation)

Place uniaxial meshes in span direction:

Place biaxial meshes in span direction:

You can use this setting to influence the direction in which meshes are placed and thus control the position of splices. Uniaxial meshes include R and K meshes; biaxial meshes are Q meshes.

Yes: the meshes are placed in span direction. At a span direction of 0 degrees, the transverse splice is along the length of the wall. There is no longitudinal splice in conjunction with regular wall heights.

No: the meshes are placed perpendicular to the span direction. At a span direction of 0 degrees, the transverse splice is along the height of the wall.

Cut mesh with exterior outline of panel:

Yes: every panel is designed individually with the mesh. The mesh is cut depending on the geometry of the panel.

No: every panel is designed individually with the mesh. The mesh is not cut; the minimum dimensions are used to create it. Thus, the mesh can also be partially outside the panel (e.g. in the case of inclined panel edges).

Minimum area for cut mesh:

[m2] Smaller pieces of mesh are omitted.