Division configuration entry

Configuration(s) Double wall: entry + Solid wall: entry + Brick wall: entry

'Element dimensions' tab

Minimum element length:

[m] Smaller elements are not created.

Maximum element length:

[m] Larger elements are not created.

Maximum element weight:

[to] Initial value for the maximum element weight. You can also define one (or more) cranes and crane locations on the drawing. In this case the program calculates the maximum weight from the lifting radii and takes this into account in the division.

Rotate from height:

[m] The element is internally rotated from the height entered, otherwise the panel could not be accommodated on the pallet.

Max. rotated length:

[m] The maximum length for rotated elements is usually the pallet width.

Rounding: (double and solid walls only)

[m] You can enter a rounding value for the element arrangement.

Joint width:

[m] The size of the joints for panel joints.

Shift value for joint: (double walls only)

[m] Value by which the joints of the two leaves are moved within double walls.

'Openings' tab

Opening division:

Enable this check box if division in openings is allowed. If not checked, then the division point is located near the opening in accordance with the value entered below if necessary.

Minimum distance to an opening:

[m] Minimum distance of a division point to an opening.