Connection configuration entry

Configuration(s): double wall: entry

'L, T-connection’ tab

L-connection - inverse:

If this check box is enabled, then the relevant connections are inverted.

Dividing joint with partitions:

If the outer leaf (or the exterior wall) is to be divided by connecting partition walls then you can select between 'in axis' or 'on side' connections. Select ‘no’ if you do not wish to divide the outer wall/exterior leaf.

Create long partition:

If this check box is activated, then the interior wall is created to extend to the outside edge of the outside leaf (or the exterior wall).

Divide at columns:

If this check box is enabled, walls are divided at columns. The manner in which the joints are created depends on the position of the column.

Dividing walls in areas adjacent to columns

The manner in which joints are created depends on the position of the column and the interaction setting for the column. The eccentricity set is taken into account for columns behind a wall or columns that do not interact.

Joints for wall design when columns are behind the wall
and for columns that do not interact

Joints for wall design when columns are within the wall

'Miters' tab

Miters at double walls permitted:

Enable this check box if you wish to create double walls with miters. Disable it if you do not want miters.

45 degrees only :

If this check box is enabled, then all miters irrespective of their actual angles are calculated as 45° miters. If disabled then the miters are formed at their actual angles. You need to make this setting in accordance with production capabilities

Inverse :

The 'inverse' form of miter helps with joints on site.

Angle symmetry :

Angle symmetry has the effect that the outer corner of the shell does not project as far and the joint becomes slightly obtuse.

Chamfer acute exterior corners:

Enable this check box if you want to chamfer the angle of outside corners and enter delta values.