Secondary bar configuration entry

Configuration(s) Half floor: calculation + Hollow core element: calculation + solid floor: calculation + BubbleDeck: calculation + Cobiax floor: calculation

Rounding:

Rounding of secondary bar lengths:

Don't: no rounding of bar lengths.

Exact: 1-4 = rounded down, 5-9 = rounded up

Round up: bars are rounded up to the value given in "Rounding value".

Round down: bars are rounded down to the value given in "Rounding value".

Rounding value:

[m] The lengths are rounded to this value.

Minimum length:

[m] Shorter secondary bar lengths are omitted.

Cut with recesses:

[m] Minimum length / Minimum width

If a recess is smaller than the value entered, then the secondary bars are not cut with the recess.

Bar overlap:

as entered: the overlap defined for an edge is used. The following fixed value is used if the bar overlap is zero.

use SetValue: regardless of the overlap defined for the edge, the following fixed value is used.

SetValue (bar overlap = 0):

[m] Fixed value for bar overlap at panel edges. This value is used even if the bar overlap is zero.

Bar overlap at recesses:

[m] Fixed value for bar overlap at recess edges. This value is only used if the bar overlap at panel edges is a fixed value. Otherwise, manual entry produces this value.