Secondary girders configuration entry

Configuration(s) Half floor: calculation + Hollow core element: calculation + solid floor: calculation + BubbleDeck: calculation + Cobiax floor: calculation

Rounding:

Rounding of secondary girder lengths:

Don't: no rounding of girder lengths.

Exact: 1-4 = rounded down, 5-9 = rounded up

Round up: girder lengths are rounded up to the value given in "Rounding value".

Round down: girder lengths are rounded down to the value given in "Rounding value".

Rounding value:

[m] The girder lengths are rounded to this value.

Minimum length:

[m] Shorter lengths are omitted.

Cut with recesses:

[m] Minimum length / Minimum width

If a recess is smaller than the value entered, then the secondary girders are not cut with the panel.

Overlap:

as entered / use SetValue

The following fixed value is always used for panel edges whose overlap is zero, regardless of the selected setting.

SetValue (bar overlap = 0):

[m] Fixed value for girder overlap at panel edges. This value is used even if the bar overlap is zero.

Overlap at recesses:

[m] Fixed value for girder overlap at recess edges.