Shear girders configuration entry

Configuration(s): half floor: calculation

Rounding:

Rounding of shear girder lengths:

Don't: no rounding of girder lengths.

Exact: 1-4 = rounded down, 5-9 = rounded up

Round up: girder lengths are rounded up to the value given in "Rounding value".

Round down: girder lengths are rounded down to the value given in "Rounding value".

Set rounding value:

To interval: shear girders are rounded up to the increment (from the girder catalog).

To SetValue: shear girders are rounded up to fixed values.

SetValue:

[m] The girder lengths are rounded to this value.

Minimum length:

[m] Shorter lengths are omitted.

Cut with recesses:

[m] Minimum length / Minimum width

If a recess is smaller than the value entered, then the shear girders are not cut with the panel.