Filling objects configuration entry

Configuration(s): Half floor: entry + Brick floor: entry

'Entry' tab

Name:

The name you enter for the filling object must agree with the name of an entry in the insulation material catalog (watch out for blanks, upper/lower case letters)!
The dimensions and density of the filling object are taken from the insulation material catalog.

Length rounding value:

Lengths are rounded down to this value [cm].

'Offsets' tab

to element edges and openings in span direction:

between filling objects in span dir.:

to girder axes:

to element edges and openings perpendicular to span direction:

Offsets to filling objects in [cm].

'Spreader ribs' tab

Minimum length of placing region in direction of span for creation of spreader ribs:

Minimum length in [cm] that must be adhered to if spreader ribs are to be created.

First spreader rib:

Offset to first spreader rib as an absolute value in [cm] or as a fraction of the length and width of the first spreader rib in [cm].

Second spreader rib:

Offset between first rib and second rib as an absolute value in [cm] or as a fraction of the length and width of the second spreader rib in [cm].

'Display' tab

Specify how filling objects are displayed in plan, in the element plan and in the Edit Element tool.

Display mode:

No view: filling objects are not shown.

Filling objects (enclosing): the boundary lines of filling objects are displayed.

Filling objects (hatching): the boundary lines of filling objects are displayed (including hatching).

Filling objects (3D): filling objects are displayed as 3D models.

Display attributes:

Enter the required attributes as follows:
L=..., H=..., P=..., C=...
. If you do not enter values, the defaults are used.