Symbols/text configuration entry

Configuration(s): edit element

Mark number height on the drawing:

[mm] Size of the mark number for fixtures, secondary reinforcement etc. on the drawing.

Panel number:

No: the panel number is not included.

bottom left as placed: the panel number is written in the ‘bottom left’ corner. In the slab program, this definition relates to the position in the placing drawing and in the wall program to the visible side of the elements.
Note: As slab panels are rotated in element plans, the number is usually at bottom left. However, the panels are always placed correctly as they are identified by the positions of their panel numbers.

centrally in the panel: the panel number is placed in the center of the panel.

Attributes for panel number:

Enter the required attributes as follows:
H=..., W=..., A=..., F=..., P=..., C=...
Information on the units is provided in the overview of the available attributes. If you do not enter values, the defaults are used.

Smooth edge/ bending shape/ bar overlap:

You can specify whether the program is to display the symbol for smooth edges, the bending shape at the supports and the text for bar overlaps.

Attributes for bar overlap:

Bars between girders:

As an alternative to drawing the longitudinal bars: you can show the number of the bars that are between two girders.
Example: 4xd12 means that there are 4 bars of diameter Ø 12 between these girders. If there are no girders, the entire longitudinal reinforcement is shown.

Attributes for bars between girders:

Center of gravity:

You can specify whether the center of gravity of an element is shown as a normal design entity or as construction lines or not shown at all.