Placing parameters for facing layers

Surfaces and areas for concrete, insulation and facing layers

Placing angle

You can define how the tiles are placed. The zero position of the tiles in the catalog is used as the basis.

• When the angle is set to 0°, the Length defined in the brick/tile catalog is applied in the direction of the wall length and the tiles are placed on top of one another in rows of the Width specified.
• When the angle is set to 90°, the Length defined in the brick/tile catalog is applied in the direction of the wall height and the tiles are placed beside one another in columns of the Width specified.

Continuous joint width at edge

You can define how joints are created at edges. Joints are always considered to be continuous and vertical to the corresponding edge. You cannot define joints of varying width. The defined placement pattern is placed within the remaining polygon.