Folder, file name

Contents

Special features

Custom mesh overview.rdlc

Overview of all custom meshes in a table.

Custom meshes you have defined as meshes with any bar combinations in Allplan cannot be output in table format as the relevant data is not available. These meshes can only be output graphically.

Cross-section catalogs.rdlc

Overview of all cross-section catalogs

In editing mode ( not selected), click the entries in the Name column to create more reports for the individual cross-section catalogs.

The general parameters are output. In addition, graphics are displayed for mesh cross-section catalogs.

You can create a report for an individual mesh by clicking the Mesh identifier in the mesh overview

Click Back to return to the overview.

Sub folder

Mesh cross-sections.rdlc

General mesh parameters and graphics, if available.

You can only create this report as a sub-report from the overview of all cross-section catalogs.

The font that is set for the creation of text in the Text module is used for the label.

Steel cross-sections.rdlc

General bar parameters.

You can only create this report as a sub-report from the overview of all cross-section catalogs.

Subordinate mesh.rdlc

General parameters of a single mesh and graphics

You can only create this report as a sub-report from the mesh overview (mesh cross-sections.rdlc).

The font that is set for the creation of text in the Text module is used for the label.