Reinforcement configuration entry

Configuration(s) Double wall (new): calculation + Concrete wall (new): calculation + Thermal wall: calculation + Sandwich wall: calculation

'Longitudinal bars' + 'Cross bars' tabs

Minimum bar length:

Shorter longitudinal and cross bar lengths are omitted.

Maximum bar length:

Longer longitudinal and cross bar lengths are omitted.

Round length to:

The rounding value for the length of the longitudinal and cross bars.

Rounding:

Rounding of the longitudinal and cross bars.

Don't: no rounding of bar lengths.

Exact: 1-4 = rounded down, 5-9 = rounded up

Round up: longitudinal bars are rounded up to the value given in "Round length to".

Round down: longitudinal bars are rounded up to the value given in "Round length to".

'Recesses' tab

Cut bars at recess width:

[m] The reinforcement at openings that are narrower than the entered value is not cut.

Cut bars at recess height:

[m] The reinforcement at openings that are smaller than the entered value is not cut.