Configuration of list generator, slab calculation

List Generator Schedule defaults

'Area calculation' tab

Billed according to:

Concrete quantity: summary of the billed area according to concrete surface area of the elements.

Free bars: summary of the billed area according to concrete surface area plus free bars.

Outer-outer: summary of the billed area according to the outside surfaces of the floor plan.

Prompt: you can specify whether calculations are to be based on outer-outer, concrete quantity or free bars.

Calculation of panel area in accordance with:

Panel shape: the panel area is calculated based on the actual panel shape.

Circumscribed rectangle: the panel areas are calculated from the enclosing rectangle.

Prompt: you can specify whether the panel area is to be calculated based on the shape or enclosing rectangle.

Standard concrete grade for half floors:

Other concrete grades are listed as ”Extra charge for concrete grade” (per m2 of floor).

'Dimensions 1' tab

Enter the standard dimensions for half floors here.

Standard panel width 1 [m]:

Enter the width for standard panels here.

Half panel width 1 [m]:

Enter the width for half panels here.

Standard panel width 2 / 3 [m]:

You can enter a second and/or third width for standard panels here. Enter 0 if you do not want to enter a second or third width for standard panels.

Half panel width 2 / 3 [m]:

You can enter a second and/or third width for half panels here. Enter 0 if you do not want to enter a second or third width for half panels.

Standard panel thickness [cm]:

Enter the standard thickness for panels here.

Round thickness for additional concrete to:

Specify whether additional concrete is to be rounded to 0.5 cm or 1.0 cm.

'Dimensions 2' tab

List half floors, element lengths >:

Half floors that are longer than the value set are listed separately as ”Extra charge for over length” (per m2 of billed area).

In addition, you can enter the standard dimensions for the other slab types.

Standard panel width 1 / 2 / 3 [m]:

You can enter up to three values for the width of standard panels here. Enter 0 if you do not want to enter a second or third width for standard panels.

Half panel width 1 / 2 / 3 [m]:

You can enter up to three values for the width of half panels here. Enter 0 if you do not want to enter a second or third width for half panels.