Lattice girders configuration entry

Configuration Brick slab: calculation

'Lattice girders 1' tab

Rounding:

Rounding of girder lengths:

Do not round: no rounding of girder lengths.

Round exactly: 1-4 = rounded down, 5-9 = rounded up

Round up: girder lengths are rounded up to the value given in "Rounding value".

Round down: girder lengths are rounded down to the value given in "Rounding value".

Rounding value:

[m] The girder lengths are rounded to this value.

Minimum length:

[m] Shorter lengths are omitted.

'Lattice girders 2' tab

Overlap for bar overlap < 0:

Use bar overlap, Use SetValue

For panel edges that have a negative bar overlap, the girder overlaps used can be the bar overlaps or fixed values.

Overlap for bar overlap = 0:

Use bar overlap, Use SetValue

For panel edges that have a 0 bar overlap, the girder overlaps used can be the bar overlaps or fixed values.

Overlap for bar overlap > 0:

Use bar overlap, Use SetValue

For panel edges that have a positive bar overlap, the girder overlaps used can be the bar overlaps or fixed values.

Overlap at recesses:

You can enter a fixed value for the girder overlap at the recess edges. This value is only used if neither a smart fixture symbol nor manual entry produces a useful shortening value.