Lifting points configuration entry

Configuration(s): BubbleDeck: entry + Cobiax floor: entry

Fixture for lifting points
File / element:

The fixture defined by the file name and element name is used as the default setting for displaying the lifting points.

Attention: the file and element names must be the same as those specified in Allplan's fixture catalog (watch out for blanks, upper/lower case letters)!

Parameters

You can use the following parameters to calculate the lifting points (connection points) taking the element width into account. The automatic feature is only available for rectangular elements. Elements whose lifting points cannot be calculated are given the Automatic fixtures corrupt state and are marked accordingly.

Factor n for length 1/n:

Initial value measured from the element edge in the longitudinal direction.

Length a:

[cm] Value added to the initial value when the two connection points are in neighboring girders.

Length b:

[cm] Value subtracted from the initial value when the two connection points are in one girder.

Length c:

[cm] Distance between the two connection points when they are in one girder.

(1) Factor + Length a

(2) Factor + Length b

(3) Length c