Secondary reinforcement configuration entry

Configuration TT floor: calculation

'Secondary bars' tab

Rounding:

Rounding of secondary bar lengths:

Don't: no rounding of bar lengths.

Exact: 1-4 = rounded down, 5-9 = rounded up

Round up: bars are rounded up to the value given in "Rounding value".

Round down: bars are rounded down to the value given in "Rounding value".

Rounding value:

[m] The lengths are rounded to this value.

Minimum length:

[m] Shorter secondary bar lengths are omitted.

Cut with recesses:

[m] Minimum length / Minimum width

If a recess is smaller than the value entered, then the secondary bars are not cut with the recess.

Bar overlap:

as entered: the overlap defined for an edge is used. The following fixed value is used if the bar overlap is zero.

use SetValue: regardless of the overlap defined for the edge, the following fixed value is used.

SetValue (bar overlap = 0):

[m] Fixed value for bar overlap at panel edges. This value is used even if the bar overlap is zero.

Bar overlap at recesses:

[m] Fixed value for bar overlap at recess edges. This value is only used if the bar overlap at panel edges is a fixed value. Otherwise, manual entry produces this value.

'Secondary girders' tab

Rounding:

Rounding of secondary girder lengths:

Don't: no rounding of girder lengths.

Exact: 1-4 = rounded down, 5-9 = rounded up

Round up: girder lengths are rounded up to the value given in "Rounding value".

Round down: girder lengths are rounded down to the value given in "Rounding value".

Rounding value:

[m] The girder lengths are rounded to this value.

Minimum length:

[m] Shorter lengths are omitted.

Cut with recesses:

[m] Minimum length / Minimum width

If a recess is smaller than the value entered, then the secondary girders are not cut with the panel.

Overlap:

as entered / use SetValue

The following fixed value is always used for panel edges whose overlap is zero, regardless of the selected setting.

SetValue (bar overlap = 0):

[m] Fixed value for girder overlap at panel edges. This value is used even if the bar overlap is zero.

Overlap at recesses:

[m] Fixed value for girder overlap at recess edges.