TT slab: slab openings

Module(s): Configurations

These parameters are defaults for the creation of rows of openings for light in TT slabs.

'Row of openings for light' tab

Opening width:

[mm] Opening width above which an opening is treated as a row for light.

Topping slab overlap:

[mm] Offset from topping slab to row of openings. This value must be complied with.

'Fixtures...' tab

By specifying two different fixtures with different height settings on the Fixtures1 and Fixtures2 tabs, you can create fixtures at the top and bottom of a slab in a single operation.

File / Entry number:

The fixture defined by the numbers of the file and entry in Allplan's fixture catalog is used as the default.

Height association:

Top level of slab / Bottom level of slab

You can associate the fixture with the top or bottom level of the slab.

Height:

[mm] Offset between the fixture’s reference point and the top or bottom level of the slab. Entering a positive value moves the fixture in the positive, global z direction.

Offset to edge:

[mm] Offset between the fixture’s reference point and the panel edge. Entering a positive value moves the fixture in the direction of the element's inside.

Placement mode:

from middle of panel edge outward on both sides / from start of panel edge / from end of panel edge

Specify how fixtures are placed.

Offset between fixtures:

[mm] Offset between the individual fixtures.

Start offset:

[mm] Edge offset of first fixture when fixtures are placed from the start or end of the panel edge. The value you enter is based on the fixture's reference point.

Minimum offset to end:

[mm] Minimum offset between the end of the placement and the edge. The value you enter is based on the fixture's reference point.