Division style (for vertical elements only)

Division style (mm)

Division

The field is divided into the number of sections specified. The element is placed at the division points.

Offset

When you enter a value here, the elements are placed at the offset specified. The remaining length is applied in accordance with the values entered for Offset at start/end.

Note: You can only enter values >= 10 (mm)! Smaller values are automatically set to 10.

Offset at start

You can specify a starting section that is not subdivided.

Offset at start, Fix

When you select this check box, Allplan uses the exact length you entered for Offset at start. Otherwise, Allplan simply makes sure that is does not fall below this value.

Offset at end

You can specify a final section that is not subdivided.

Offset at end, Fix

When you select this check box, Allplan uses the exact length entered for Offset at end is used. Otherwise, Allplan simply makes sure that is does not fall below this value.