Tip: Floor finish from Room, Finish tab

Example: Label style for working drawing (with two foils)

Instead of using a fixed value for the structure of the floor covering, you can also use the values entered in Room, Finish tab, Floor surfaces area or in Finish Specifications, Floor surfaces area.

Follow the steps below:

• For TL FF go to Formula, click ( in the Operators area, then click Attribute and select BL from Archit. quantities.
• In the Operators area, click +.
• Now click Finish… in the References area.
  In the Label object area in the Finish Label dialog box, select Floor surface; under Read attribute, select Layer thickness from Archit. quantities, and under Layers to analyze select All. Click OK to confirm the entries.
• In the Operators area click ), then / (for division) and enter 1000 in the Number area (the values in formulas are always calculated in mm!).
  The formula should now look like this:
  (BL+MT_Floor(Layer thickness;1;2;3;4;5;6;7;8;9;10))/1000
  Click OK to confirm the Formula dialog box.
• Enter 3.5 mm for the text height. Under Prefix enter TL FF; set the text anchor point to bottom left
• Now follow the steps for TL UF etc.