Secondary bar configuration entry

Configuration Half Floor: Reinforcement + Hollow Core Element: Reinforcement + Concrete Slab: Reinforcement

Rounding option:

Rounding of secondary bar lengths:

Don't: Bar lengths will not be rounded off.

Exact: 1-4 = round down; 5-9 = round up

Round up: Bars will be rounded up to the rounding value.

Round down: Bars will be rounded down to the rounding value.

Rounding value:

[m] The program rounds off to this value.

Minimum length:

[m] Shorter secondary bar lengths are omitted.

Cut with recess:

[m] Minimum length / Minimum width

If a recess is smaller than the value entered, then the secondary bars are not cut with the recess.

Bar projection:

As entered: Uses the projection defined for an edge. If the bar projection is 0, the program uses the following fixed value.

Use fixed value: regardless of the projection defined for the edge, the following fixed value is used.

Fixed value (bar projection = 0):

[m] Fixed value for the bar projection at panel edges. The program uses this value, even if the bar projection is zero.

Bar projection at recesses:

[m] Fixed value for the bar projection at recess edges. This value is only used if the bar projection at panel edges is a fixed value. Otherwise, manual entry produces this value.