Names improved in catalogs and configurations for MWS

Several texts were amended in both the diameter catalog under Catalogs and in Configurations for attached reinforcement as these were not clearly understood before and it was therefore not clear if the settings applied to a single wire bender or a bending beam.

In the diameter catalog this affects the settings on the Welding 5 tab.

• The text Zone X was replaced by Zone X for single wire benders (with X = 1, 2 and 3) and the text Width of restricted area was replaced by Width of restricted zone instead.
• For the additional settings maximum setting of bars to be bent at the same time and maximum number, the bending beamsheader has been supplemented.
• In addition, the setting for the overlap length was moved to the Welding 3 tab.

Within the configurations for attached reinforcement this affects the settings in the title Bending shapes, Slab basic reinforcement, Wall basic reinforcement, Stirrup cages as well as on-site meshes.

• In the title Bending shapes within the tab General 1 the old option Definition of restricted zones has been renamed to Definition of restricted zones for single wire benders.
• Furthermore in the title Bending shapes on the Restricted zones for 90° bars and Restricted zones for 0° bars tabs, the text Zone X has been replaced by Zone X for single wire benders (with X = 1, 2 and 3) and the text Width of restricted area has been replaced by Width of restricted zone instead.
• On the Restricted zonestab for the titles Slab basic reinforcement, Wall basic reinforcement, Stirrup cages as well as On-site meshes there is the notification The restricted zones defined here always refer to the entire mesh in addition to the restricted zones for the individual bar. Specific areas in a mesh of bars could be kept clear with the aid of these general restricted areas. added so that the difference to the restricted zones is clearer.