Filling objects configuration entry

Configuration Half Floor: Design + Brick slab: Design

"Entry" tab

Filling object material:

You must specify the filling object material used here. The list box provides all entries that are defined in the Insulation Material Catalog.
The dimensions and density of the filling object are taken from the insulation material catalog.

Length rounding value:

Lengths are rounded down to this value [cm].

'Offsets' tab

To element edges and openings in span direction:

Below one another in span direction:

To axes of lattice girders:

To element edges and openings perpendicular to span direction:

Offsets to filling objects in [cm].

'Spreader ribs' tab

Minimum length of placing region in direction of span for creation of spreader ribs:

Minimum length in [cm] that must be adhered to if spreader ribs are to be created.

First spreader rib:

Offset to first spreader rib as an absolute value in [cm] or as a fraction of the length and width of the first spreader rib in [cm].

Second spreader rib:

Offset between first rib and second rib as an absolute value in [cm] or as a fraction of the length and width of the second spreader rib in [cm].

"Display" tab

Specify how filling objects look in plan view, in the element plan and in the "Edit Element" tool.

Display mode:

no representation: filling objects are not shown.

Filling objects (enclosing): The boundary lines of filling objects are visible.

Filling objects (hatching): The boundary lines of filling objects are visible (including hatching).

Filling objects (3D): Filling objects appear as 3D models.

Display attributes:

Enter the required attributes in the form
L=..., H=..., S=..., C=...
: If you do not enter values, the program uses the default values.