'Lattice girders' configuration entry

Configuration Half Floor: Design

Static load capacity:

The bottom booms of the lattice girders will be included in the calculations. Note that for fitted panels, a narrow girder spacing can lead to a higher as-value than for a standard panel. It can also result in a reduced level of reinforcement being used.

Place girder only up to panel width of …

[cm] Uses 1 lattice girder up to a panel of this width. For a wider panel, at least 2 girders must be used.

Rotate lattice girders:

Specify whether the program rotates the lattice girders of attached reinforcement before placing them. When you select this check box, the program rotates the lattice girders by 180° about their longitudinal axes. This affects the number of locked zones.



Allplan

(C) ALLPLAN GmbH

Privacy policy