Create profile for fitted panels on the placing edge of concrete slabs

When it comes to the design or modification, fitted panels on the placing edge could not have a profile on a support in the span direction (= longitudinal side), provided you have not selected the support and then, in the corresponding dialog Support moved to the Support tab and specified the settings for a Profile at that point.

This has been amended such that the profile of a fitted panel on the edge can be specified without selecting the support dialog. To do so, under Properties, Profiling within the dialog for the profile parameters in the settings for the Sections for longitudinal side , a check box Profile of fitted pane on edge = yes/no has been added. If this new check box is active then the profile of the fitted panel on the edge is created with the same profile as the other sections for longitudinal sides.

The option Profile in the group Support on the index card Support in the dialog box for the support is then set automatically and the selected profile is transferred. If you would like to change the profile on the edge, you must click the support and when in the Support dialog, amend the profile if required.

In order to deactivate the profile with a fitted panel on the edge, you can either deactivate the check box in the Profile parameter dialog or the Profile option in the dialog for Change support .

Note: Within Configurations and under Slab programs, Solid slab, Design within the title Profiles - for setting the defaults of profiles on the placing edge - an additional option Profile for fitted panels on placing edge = yes/no has been added.