Choice of elements while creating production data revised

Previously, it was necessary to select in a toolbar the elements for which production data should be created. In the future, this selection will no longer be necessary. After selecting the Production Data, NC Generator you select, without any further settings in a toolbar, the precast elements (slab, wall, structural precast element and precast element) and/or MWS reinforcement ( MWS Reinforcement Group, free MWS mesh from the Mesh task area and MWS meshes and cages, which are created via Fixtures from article catalog) and/or directly from Free reinforcement . The program then intelligently decides which element type(s) are selected, then creates the production data corresponding to the parameters that were predefined in the configurations.

Depending on the type, the data is then displayed accordingly in the production data. If a MWS reinforcement group is within a precast element then it is written together with the data for the precast element into a single file.

In order to better distinguish between precast elements ( = slab elements, = wall elements, = precast elements and structural precast elements) or MWS reinforcement ( = MWS·Reinforcement·Group) then the free reinforcement group is now highlighted in the NC Generator dialog with its own symbol ( = free reinforcement) in the bottom-left overview of selected elements.