Production file name for production or ERP data

The Production file - Name convention defined up to version PLANBAR 2021 in the now omitted Configuration, Site facilities, General, Production Data Transfer, General on the Program Flow tab can now be defined again. A complete elimination of this parameter was not possible, since it is used by many customers simultaneously with the export file name, as an alternative way to create names (e.g. to control different systems that require different name patterns).

Therefore, a second export name has now been provided under Configuration, General, Program Flow, Export name on the Export file name tab. This second name is called Production file name for production or ERP data for pragmatic reasons, so that the former setting from the configuration is easier to assign. The entries for this are made in the same way as the other settings on this tab.

When the configurations are opened for the first time, the existing configuration under Production file - Naming convention from Configuration, Site facilities, General, Production Data Transfer, General on the Program Flow tab is converted to the new setting.

There are no changes for the Production Data, NC Generator and List Generator functions. You can continue to freely decide here whether the Export file name or the Production file name should be used.

Note: Please check the correctness of the attribute numbers used after the update. There are two possible attributes for the floor in Allplan that were used earlier. Slab above (@829@, string) and floor (@1092@, string). If floor was not used, slab over was used. This now no longer works, because at the time of the conversion of the setting it is not clear which attribute is in use. Therefore, the attribute floor (@1092@) is entered during the conversion. If the attribute slab over is used, please replace the attribute number with @829@!