Place in view

Tool(s): Special Placements

To assign placement quantities to a bar view

1. Click Special Placements (How).
   

   Activate Special Placements in one of the following ways

   • Menu bar: Create Engineering Bar Reinforcement

   • Palette: Tools Create area in the following module(s):

   Bar Reinforcement

   • Configuration: Engineering Bar Entry and Placement flyout
2. Select the mark you want to place by clicking a reinforcing bar or a bar placement. Alternatively, enter the mark number in the dialog line.
3. Set the placing mode to Place in View and click OK to confirm.
4. Set the placing parameters to define the number.
   The number of pieces, spacing and reinforcement percentage are not mutually dependent, as there is no no geometric placing region.
5. Click OK to confirm the settings.
6. Press ESC to skip the labeling process and retain the current scope of the label. Allplan automatically updates the mark label.
   If, on the other hand, you have changed something, you have to place the new label and delete the old one.
7. Select the Automatic mark number option in the input options if the program is to create the mark number at the beginning or end of the label depending on the drop-in point specified. In addition, define the Anchor point of the label.
8. To change the current scope of the label, specify the label parameters, place the label for the placement (you can set the text angle before you do this) and, if required, create the leader manually.
   Then delete the old mark text.