DT Rearrange

Task area Warped Slabs

You can use this tool to change the mark numbers of the warped double tee beams.

To change the mark numbers of double tee beams

• You have added the DT Rearrange tool to the Actionbar by means of Actionbar Configurator, or you have added this tool to a toolbar by selecting it in the More tools with icons category in the Customize dialog box.

1. Open the drawing file with the placement of the warped double tee beams.
2. Click DT Rearrange.
3. In the palette, define the mark number with which you want to start and the additional text.

   Note: The program proposes the mark number following the greatest mark number that is already assigned.

4. Select the required double tee beams individually or by enclosing them in a selection rectangle.

   Allplan changes the mark numbers of the selected double tee beams in ascending order. If the mark number with which to start is smaller than or equal to the greatest mark number, Allplan uses the mark number following the greatest mark number.

Note: This tool does not assign the same mark number to double tee beams that are geometrically identical. If this is required, modify the placement and change the mark number.