Mesh rounding-off and dimensions

Click Rd to enable/disable automatic rounding-off of length and width values:

• when Rd is activated, the meshes are rounded up according to the values set for Round-off value for mesh length/mesh width in the Options, Reinforcement page, Mesh reinforcement area.
• when Rd is deactivated, automatic rounding-off is disabled.

Consequently, the / Flush/Not Flush setting is important.

You can specify whether the display/calculation of the meshes at the placing area boundary is cut or not.

Click Not Flush or Flush to set the placing end: This causes the switch to be applied immediately:

• when appears on the button, the area is covered with entire meshes
• when appears on the button, meshes are placed right up to and flush with the boundary. Any mesh sections that protrude beyond the boundary are cut.

• When it is set to Not Flush, the meshes will project beyond the boundary of the outline polygon by the round-off value set here.
• When set to Flush, the mesh reinforcement is positioned in such a way that it is exactly flush with the boundary of the outline polygon. In this case, the overlap with the previous mesh is increased accordingly.