Additional tools for placing fixtures

Several tools

Fixture

Place HALFEN-DEHA fixture

Place PEIKKO fixture

Place SCHÖCK Fixture

Place PHILIPP fixture

Use this to select the point at which the element is attached to the crosshairs.

SymPnt

Use this to select the drop-in point you have defined when the element was created.

Ang=0/?

This is where you can choose between an angle of 0 and any angle (?). After selecting ?, you can enter the angle after placing the element, or you can click a line and match its angle.

Num=1/?

This is where you can choose between a number of 1 and any number (?) of your choice. When you have selected ?, you can place the element multiple times in the workspace.

WS=0/1

Use this to enable/disable an automatic feature that brings a fixture you are about to insert in a wall into the correct position. When you select WS=1, the program automatically rotates the fixture and places it on the inside of the architectural wall.

Size

Use this to define the dimensions of the element.

• The Original size option uses the dimensions specified when you defined the element.
• The Free size option allows you to enter any value for the length, width and height of the element. Note, however, that dimensions that are different to the original size are only considered if you explicitly specified (during creation) that the fixture can be resized later.
• The Standard size option lets you select predefined dimensions in accordance with the existing element.

3D

Use this to rotate the element by predefined values about the x, y or z axis.
Select the Axis of rotation and then choose a Rotation angle. Clicking the Original position button restores the original position of the element.