Module(s): Bar Reinforcement
After you have defined a mark, you can place it using the Place Bar Shape or
Place tool.
The following example shows how to place a stirrup along a placing line. Other approaches are described in the tool descriptions in the help for Allplan. A detailed example is provided in the manual.
Information on the placing methods Align, Move and Rotate is provided in the section section entitled "Reinforcement methods".
Example: placing a stirrup |
||
Requirement: |
||
1 |
Click tool |
|
2 |
Click mark and select Linear placement if necessary |
|
3 |
With method 3: |
|
4 |
Click points on the placing line in the view |
|
5 |
With methods 1 and 2: |
|
With method 2*): |
|
|
6 |
With methods 1 and 2 in the input options: |
|
7 |
Set placing parameters |
|
8 |
Press ESC twice when labeling was active when you created the placement or select |
|
9 |
Configure label and place it in the workspace |
|
10 |
Quit tool |
Press ESC |
Result: |
||
*) If there is no reinforcement view if you selected New when entering the reinforcement |
(C) Allplan GmbH | Privacy policy |